Interchangeable covers
Turning old into new:
You no longer like your old beanbag motif? Has your CI changed? Don't panic! You can easily change the cover in a few simple steps. And so you have an "almost" new beanbag or cube that can be adapted to your needs at any time.
A little mishap?
As the covers of our products are interchangeable, it is of course also possible to clean them very easily if they have become dirty or stained.
Cover machine washable
Do not spin
Do not tumble dry
Do not iron
Do not bleach
Do not dry clean
Recyclable
Lounger Cover Change
Cube Cover Change
If you want to turn the design of your lounger upside down, start by turning the entire lounger upside down!
Step 1
The covers of the seat cubes can also be easily replaced. Incidentally, the cores of the cubes always fit into the x2 and x3 models of the same size, for example Cube40, Cube40x2 and Cube40x3 have cores of the same size, just in different numbers.
Open the super strong Velcro fastener. Attention, this requires some strength.
Step 2
Turn the cube upside down and you will find a Velcro strip on 3 edges at the bottom.
In the 4 corners of the cover you will find straps with which the inner bag is attached. First undo the knots to the right and left of the Velcro.
Step 3
Open the Velcro tape all the way around. Please note, one side is firmly sewn and has no Velcro tape. You will also find the care instructions there!
You can now pull out the inner bag. If it is pulled out far enough, you can also undo the remaining two knots in the corners.
Your lounger is now naked.
Step 4
Now slowly remove the foam cube from the cover. It is best to try to pull on the casing so that the core is not damaged.
To get the inner bag into the new cover, we recommend that you first tie the 2 bottom corners back to the cover. Then gradually pull the cover over the inner bag and gently press the filling with it.
A little shaking usually works wonders!
Step 5
Voila! Now you have the single foam core, which you can also use with the X models of the same size (e.g. Cube 45x2).
After you have tied the last two knots tightly and the inner bag sits properly in the cover, close the Velcro and press it tightly together again.
Step 6
Pull your new cover over the core. Make sure that the 4 edges sit neatly on the foam, then the cube will look best. Then close the 3 Velcro edges and turn the cube the right way up again.
That was it. That's how quickly and easily the covers of the beanbags can be changed.
Done
It's so easy to change the seat cube covers!
